SVC-500
Line Control Amplifier with Balanced Input/Output Transformers

  • All of the transformers (Power, Choke and Input/Output) are specially manufactured by Tamura Corp.
  • A hard-wired is mainly used for the circuit. In addition, Printed Circuit Board is used in a little part (amplification section) only.
  • This model has a design matching with SV-amplifiers except for SV-300BSM because of mostly same Width and Depth. (which can be used with SV-amplifier setting it on the top panel.)

Specifications for SVC-500
Tubes ECC82 x2, 6X4 x1
Circuit Design "Cathode Follower"
Line Inputs XLR (Balanced): x1 (CD1) (*1)
RCA (Unbalanced): x4 (CD2, TUNER, AUX1 and AUX2), also with REC IN x1
Input Impedance 100kohms (Unbalanced)
600ohms (Balanced)
Line Outputs XLR (Balanced): x1 (*2)
RCA (Unbalanced): x1, also with REC OUT x1
Output Impedance 10kohms (Unbalanced)
600ohms (Balanced)
Frequency Response 10-130kHz/-3dB (VR:MAX)
MAX Output 50V/1kHz
Gain 22dB/1kHz
Noise level less than 0.1 mV
Power Supply 100, 120 and 220-240 VAC can be accepted at 50/60Hz (must select one) (*3)
AC Connector Equipped built-in noise filter with detachable AC cord
Dimensions W360/H90/D300 mm
Weight 8.5 kg
this specifications are subject to change without notice.

*1 It is selectable at "CD1" position (left end) with the selector knob on the front panel.
*2 It can be chosen with the left (toggle) switch on the front panel.
*3 Now, we deliver this model with exchanging between two kind of power transformers like below in order to be used for all over the world.
1) 100V-120V version
2) 220-240V version


The full size pictures Front (JPG49K)
Inside (JPG76K)
Rear (JPG47K)